14
OPM-171/B
Make sure all DC battery connections are tight and clean.
Follow battery manufacturer’s recommendations.
This charger is mounted under the customer connection
on the control side of the generator. The charger will
need to be plugged to a customer’s power source, using
a customer supplied heavy duty, UL approved extension
cord. The receptacle is to be powered by a GFCI circuit and
installed in accordance to the US National Electric Code. It is
suggested that this circuit be fused to 20 Amps.
Low/Charge Mode:
The illuminated blue power LED and red low/charging LED.
This indicates the Low/Charge mode is in process. When
completed the RED Low/Charge LED will turn off.
Auto Maintain Mode:
The illuminated Green auto maintain LED. This indicates
your 12volt battery is fully charged. During short or long
term storage periods, Auto Maintain (Energy Saver) mode
will monitor and auto maintain a battery only when needed
to maintain a full state of charge. This feature significantly
reduces AC Power consumption, lowers operating costs
and maximizes reserve power performance.
BLOCK HEATER
The block heater on this unit is a 1500 watt (12.5 amp)
heater and can be powered by a 120V, 15 amp, GFCI
protected outlet. The block heater is thermostatically
controlled when plugged in will maintain the engine
coolant temperature between 100 and 120 degrees F. The
generator is also equipped with a trickle battery charger.
This can be powered from the same 15 amp GFCI protected
outlet or it can be powered from a separate circuit.
To Next Page
Loading...
