What does it mean if the LED on my Wincor Nixdorf Printer blinks twice and then stays on?
If the LED blinks twice and then stays on, the voltage is low. Wait for the voltage to recover, or try a new power supply.
What to do if my Wincor Nixdorf TH250 Printer starts printing but stops during the process?
If your printer starts to print but stops while printing the receipt, it is likely due to a paper jam. To resolve this, open the top cover, inspect the knife, and remove any jammed paper.
What to do if my Wincor Nixdorf TH250 receipt does not come out all the way?
If the receipt does not come out all the way, the paper may be jammed. Open the top cover, inspect the knife, and clear any jammed paper.
Why is my Wincor Nixdorf Printer printout light or spotty?
A light or spotty printout could be due to a few reasons: * The paper roll may be loaded incorrectly; check that the paper is loaded properly. * The thermal printhead could be dirty; use the recommended thermal paper roll. * There may be variations in the paper; increase print density in the printer Configuration Menu to 110% or 120% as needed (monochrome printer only).
What to do if my Wincor Nixdorf Printer LED blinks three times, then off?
If the LED blinks three times and then remains off, the printer is likely out of paper. Load a new paper roll to resolve this issue.
Why does my Wincor Nixdorf TH250 Printer have a colored stripe on the receipt?
A colored stripe on the receipt indicates that the paper is low. Replace the paper to resolve this issue.
What does it mean if the LED on my Wincor Nixdorf TH250 Printer blinks twice, then off?
If the LED blinks twice and then remains off, the printer is undergoing flash programming. Allow the printer to finish programming.
What to do if my Wincor Nixdorf TH250 Printer LED blinks four times, then stays on?
If the LED blinks four times and then stays on, the thermistor is out of range. Allow the print-head to cool down.
What to do if my Wincor Nixdorf Printer color print is light?
If the color print is light, this could be due to variations in the paper. Increase the energy level of the print-head in the “Color Density Adj” of the printer configuration menu.
What does it mean when the LED on my Wincor Nixdorf Printer blinks slow and steady?
A slow, steady blinking LED indicates a non-Wincor power supply is being used. Switch to a Wincor power supply.
General| Brand | Wincor Nixdorf |
|---|---|
| Model | TH250 |
| Category | Printer |
| Language | English |
To Next Page
