18
Operations
Pre Run Setup
Lower machine to floor.
Select continuous setting to start solution spray or
select intermittent setting to enable use of trigger
switches to start solution spray.
The intermittent setting requires the operator to hold
any one of the three trigger switches in the "on" position
with the fingers, and is typically used in small areas
where short cleaning passes are made.
The continuous setting allows the operator to set the
switch in the "on" position with one touch, and is
typically used in large areas where long cleaning
passes are made.
Place main switch in machine cleaning mode to start
cleaning process.
86302100 CLIPPER DUO
To Next Page
Loading...
Need help?
General
