23
Maintenance
Service Schedule
MAINTENANCE DAILY WEEKLY QUARTERLY
Check machine for cord damage *
Check recovery dome and gasket for damage and cleanliness *
Check brushes - should be clean with no lint or strings attached *
Remove bearing cap from end of brush. Clean bearing and cap. *
Inspect vac shoe for blockage; remove fibers with coat hanger, etc. *
Check hoses for wear, blockages, or damage *
Check handles, switches, and knobs for damage *
Run one gallon of water through solution system *
Clean out recovery tank, clean float screen and check float valve to
make sure it moves freely
*
Clean out solution *
Clean outside of all tanks and check for damage *
Run vac motor for at least one minute to allow motor to dry *
Store with dome off tank to allow the tank to dry *
Check all bearings for noise *
Check all gaskets for wear and leakage *
Check pump pressure; observe spray pattern and check with gauge
if necessary
*
Check and clean solution screen *
Check brush for wear; ensure bristles are not damaged *
Check condition of vac shoe and frame for damage *
Check overall performance of machine *
Check vac motor carbon brushes *
Check belts for wear and replace as necessary *
Check cables for fraying *
86302100 CLIPPER DUO
To Next Page
Loading...
