30
Maintenance
Troubleshooting
PROBLEM CAUSE SOLUTION
No Power, Nothing
Runs
Is the cord plugged in. Plug in cord.
Circuit breaker tripped in building. Reset breaker.
Faulty switch. Call for service.
Faulty power cord or pigtail. Call for service.
Vacuum Motor Will Not
Run
Vacuum circuit breaker tripped. Reset breaker.
Faulty main vacuum switch. Call for service.
Loose wiring. Call for service.
Faulty vac motor. Call for service.
Vacuum Motor Runs
But Suction Is Poor
Debris lodged in vac shoe. Remove debris from vac shoe.
Dome gasket defective or missing. Replace as necessary.
Vacuum hose cracked or hose cuff loose. Replace or repair as necessary.
Recovery tank full / float ball stuck in the
up position.
Turn off vac motor. Drain and rinse
recovery tank.
Poor Or No Water Flow Pump switch in intermittent position.
Turn to continuous or use buttons on
handle
(Carpet Is Streaky) Jets clogged or missing.
Clean using a vinegar /water solution or
replace.
Solution filter clogged.
Drain solution tank and clean solution
filter.
Faulty solenoid. Call for service.
Brush Does Not Spin Main switch off or in hand tool mode. Turn main switch to machine mode.
Brush circuit breaker tripped. Reset circuit breaker.
Brush belt broken. Replace as necessary.
Faulty brush motor. Call for service.
86302100 CLIPPER DUO
To Next Page
Loading...
Need help?
General
