20
Operations
Operating The Machine
Start at wall closest to power outlet. For large areas flip
handle and operate machine in parallel passes, over-
lapping brush path. Clean perimeter last.
During operation, observe the following: This machine
is equipped with clear dome to facilitate operator
viewing of dirty solution and vacuum air flow.
During operation, observe the vacuum intake. Large
amounts of water or foam entering the vacuum system
can damage the vacuum motor. If you notice either
condition, shut down the machine immediately. Empty
recovery tank and/or add defoamer to recovery tank.
Use right side of machine for cleaning against walls.
After cleaning, turn off all controls, and carefully unplug
machine.
ALTERNATE CLEANING PATH
SOLUTION INTAKE
VACUUM INTAKE
STEP 5
STEP 6
OFF
POSITION
CENTER
SHUT
DOWN
86302100 CLIPPER DUO
To Next Page
Loading...
Need help?
General
