21
Operations
Start at wall closest to power outlet. For large areas
flip handle and operate machine in parallel passes,
overlapping brush path. Clean perimeter last.
5. During operation, observe the following: This
machine is equipped with clear dome to facilitate
operator viewing of dirty solution and vacuum air
flow.
During operation, observe the vacuum intake.
Large amounts of water or foam entering the
vacuum system can damage the vacuum motor. If
you notice either condition, shut down the machine
immediately. Empty recovery tank and/or add
defoamer to recovery tank.
6. Use right side of machine for cleaning against
walls.
7. After cleaning, turn off all controls, and carefully
unplug machine.
SHUT
DOWN
STEP 7
STEP 6
ALTERNATE CLEANING PATH
STEP 5
SOLUTION INTAKE
VACUUM INTAKE
OFF
POSITION
CENTER
86408790 Operator’s Manual - Clipper Duo
To Next Page
Loading...
