Select 3-LNB (18”x20”) or 3
Satellites. If given the option
of SWM or Multi-switch, select
Multiswitch.
Now power on the Mission
antenna, and allow it a few
minutes to acquire signal.
(After the search routine is
complete, the in-motion antenna
will take another 6 minutes
before going into “Sleep Mode”.
Once it does, the unit will be completely silent.)
If you want to check signal strengths, choose Signal Strength from the menu
options before returning to this screen.
Now, press Continue.
In your receiver menu, you will
need to identify the Satellite
Menu. Once there, find the
option for Satellite Setup.
If your receiver differs from the options shown, you may need
to consult your receiver manual. The wording and display used
in your receiver may differ slightly.
For more information on receiver compatibility and
programming, visit www.winegard.com/receivers.
For help, email help@winegard.com or call 1-800-788-4417
Press Menu on your remote,
and then select Parental, Fav’s &
Setup.
Select System Setup.
Your installation will be verified.
You may be required to press the
DASH (-) before proceeding
(underneath #7 on the remote).
Continue with step 7 on the next page.
1
2
3
5
6
4
DIRECTV Receiver Setup
Disclaimer: Receiver setup instructions are accurate at time of printing and may change without
notice. Call Winegard tech line for assistance: 1-800-788-4417.
11 Mission Antenna
Mission Antenna 12
DIRECTV Receiver Setup
To Next Page
Loading...
Need help?
General
