3
ALL MODELS
STEP 5: Attach antenna head to lift tubes with two (2)
steel pins as shown in Figure 2. Align holes in leveling
bracket on back of antenna head with holes in lift tubes,
insert pins and secure in place with (2) E-clips. Use
pliers and get a firm grip on E-clips. Fit clips into
groove on pins and snap into place.
STEP 6: Attach coax connector to jack on back of
antenna head, slide weather boot into place over boot
collar as shown in Figure 3.
STEP 7: Mount antenna and lift on roof in travel position.
Apply a liberal amount of approved nonhardening sealing
compound on bottom of base plate and roof area around
hole. See Figure 4. Secure base plate with screws
provided. Apply sealing compound over mounting
screws. See Figure 4.
STEP 8: Lay ceiling plate on top of directional handle
with pointers aligned and slide assembly over rotating
base shaft in ceiling. Make pilot holes in ceiling. Mount
ceiling plate with directional handle in place with
screws provided. See Figure 5.
STEP 9: Assemble directional handle, spring, nylon
bearing, directional handle decal and elevating crank as
shown in exploded view in Figure 5. Remove backing
from crank cover decal and press firmly inside directional
handle. Slide all parts over elevating shaft and install
elevating crank so set screw is on one of the six flat sides
of elevating shaft before tightening screw.
WARNING: Once set screw touches shaft, tighten
only 1/4 turn more. Set screw simply holds elevating
crank on. DO NOT OVERTIGHTEN!
NON-AMPLIFIED MODELS ONLY
STEP 10: Run downlead to TV set location and make
connection to antenna terminals of TV set.
FIGURE 4
Leveling Bracket
(2) Steel Pins
Lift Tubes
(2) E-Clips
Antenna
Head
Boot Collar
Coax Connector
Weather
Boot
FIGURE 5
CEILING PLATE
DIRECTIONAL
HANDLE
SPRING
DECAL
NYLON BEARING
ELEVATING CRANK
NOTE:
Apply non-hardening
sealing compound
between Base Plate and
roof of vehicle. Check
manufacturer’s
information for
compatibility with your
roof material
CAUTION:
Do not get sealing compound
on bearing surface between
base plate and Rotating Gear
Housing. Do not paint top of
Base Plate or around Rotating
Gear Housing.
FIGURE 3
FIGURE 2
POINT TO REAR
OF COACH
Rev. 5/00