What to do if Winegard TV Antenna shows 'STOW FAILURE ANT NOT STOWED'?
If your Winegard TV Antenna fails to stow and displays 'STOW FAILURE ANT NOT STOWED', do not move the vehicle. Attempt to stow the Trav’ler again. If it continues to fail, inspect for any obstructions that may be preventing the stowing process.
What to do if Winegard TV Antenna stow failure ant not stowed?
If your Winegard TV Antenna stow failed because the antenna is not stowed, try stowing it again. If it fails again, check for obstructions that may be preventing it from stowing properly.
How to fix Winegard TRAV'LER SK-3003 TV Antenna connection failed?
If the Winegard TV Antenna connection failed, check the data cable connection on the back of the TRAV’LER interface box to ensure it is properly connected.
Why El home failure on Winegard TRAV'LER SK-3003 TV Antenna?
If you are experiencing an EL HOME failure with your Winegard TV Antenna, it means something is preventing the TRAV’LER mount from raising to find the HOME position. Look for any obstructions, especially if the unit was recently manually raised or the electronics were replaced. It may be necessary to reset the calibration.
What to do if Winegard TRAV'LER SK-3003 not receiving 99 and 103?
If your Winegard TV Antenna is not receiving 99 and 103, make sure the B-Band Converter is installed.
What to do if Winegard TRAV'LER SK-3003 stow failure stow unknown?
If your Winegard TV Antenna stow failed and the stow status is unknown, check the data cable connection on the back of the TRAV’LER interface. Ensure it is properly connected.
What to do if Winegard TRAV'LER SK-3003 SK motor is stalled?
If your Winegard TV Antenna's SK motor is stalled, something is preventing the TRAV’LER reflector and LNBF from rotating. Look for any obstructions. If there are no obvious obstructions, further assistance is needed.
What to do if my Winegard TRAV'LER SK-3003 shows 'EL HOME FAILURE'?
If the Winegard TV Antenna displays 'EL HOME FAILURE', something is likely preventing the TRAV’LER Mount from raising to find the HOME position. Inspect for any obstructions, especially if the unit was recently manually raised or the electronics have been replaced.
What to do if my Winegard TRAV'LER SK-3003 TV Antenna stow failed and is not stowed?
If the Winegard TV Antenna stow failed and is not stowed, try to stow the Trav’ler again. If it fails again, check for obstructions.
What to do if my Winegard TRAV'LER SK-3003 connection failed?
If the Winegard TV Antenna connection fails, check the data cable connection on the back of the Trav’ler Interface to ensure it is properly connected.
General| Type | Automatic Satellite TV Antenna |
|---|---|
| Weight | 30 lbs |
| Power Requirement | 12V DC |
| Mounting | Roof Mount |
| Warranty | 2 Years |
| Number of Receivers Supported | 2 |
| Satellite Acquisition | Automatic |
| Mounting Type | Roof Mount |
| Signal Acquisition | Automatic |
| Operating Voltage | 12V DC |
| Compatibility | DISH, DIRECTV |
| Azimuth Range | 360° |
To Next Page
