DISH
®
Receiver Setup for SK-1000
The following instructions assume that the TRAV’LER® antenna has found and locked onto satellites 110°,
119° and 129°. There should be an asterisk next to 110°, 119°, and 129° on the TRAV’LER interface.
The following instructions are based on a ViP
®
211 receiver. If your receiver differs from the options shown,
you may need to consult your receiver manual. The wording and display used in your receiver may
differ slightly.
If your receiver is showing a switch type of DPP1K.2, then a check switch test is
not necessary. In that case, skip to step 7 to complete DISH receiver setup.
If it is of any other type other than DPP1K.2, then check that there are no
checkmarks by SuperDISH or Alternate, and select Test.
Select option 1,
Point Dish.
Press Menu on
your remote.
Select option 6,
System Setup.
2
4
1
3
5
Select option 1,
Installation.
Press Cancel
four times to
exit the receiver
menu.
The receiver
setup is now
complete.
6 7
Verify that the
check switch
resulted in a
switch type of DPP
1K.2 and that there
is a green OK
status on Satellite
110, 119 & 129.
Select
Check Switch.
For Help, Call 1-800-788-4417
Winegard and TRAV’LER are registered trademarks of Winegard Company.
DISH and ViP are registered trademarks of DISH Network L.L.C.
Need help?
General
