5
Battery
Battery Charging Base
USB Port
Charging State Indicator
Connect to a suitable power source
(A fully charging takes approx. 1h 30mins.)
The max flight time is tested in a lab environment, vary depending on environmental
condition, for reference only.
When an alternating green and red LED flashes which indicates a battery error has occurred.
The performance of LiPo batteries will be affected by the relatively lower temperature which
would shorten the flight time. To warming up the battery to around 20℃ before takeoff will
effectively increase the flight time.
If the battery need to be stored for a long time, please make sure the battery level is between
40%-60% for a over discharge protection. Charge the battery every once in a while to keep
the battery level.
Insert the battery into the compartment.
The power button is located at the bottom
of the aircraft.
Flip over the aircraft, use your thumb or a
coin to lever up the compartment lock and
pull out the battery.
Press and hold the power button of the aircraft for 5 seconds to power on the aircraft.
A continuously short beeping sound indicates the aircraft is self-checking, a long
beeping sound indicates self-checking is complete and the aircraft is ready to fly.
Press and hold the power button for 5 seconds to power off the aircraft.
Battery Installation
Remove the Battery
Power On/Off
S6 User Manual
To Next Page
Loading...
