4.
Replacing Filters
▶
▶
① Install the filter, top side up, into the unit until it is fully inserted.
Grasp lower handle near bottom of the unit and push in until the filter
locks into place.
•
The top of the filter shows the opening into the filter. Whereas the bottom is
solid, with no opening.
•
When installing the filter you will know it is fully inserted because it will no
longer be able to be pushed further.
②
Replace the back panel by first inserting the latch at the bottom
edge into the base of the unit, then rotate the panel upward toward
the top of the unit until the panel snaps into the unit.
5.
Resetting The Unit
① After replacing the filter, turn the
power back on and then press and
hold the Check Filter button for at
least 5 seconds to RESET the filter
life in your unit.
To Next Page
Loading...
Need help?
General
