Winterhalter CTR Series - Changing the tank water; Switch off the warewasher

English | 6 | Operation
34 | 89014478; 2020-06 | Operating instructions CTR Series
Select alternative wash mode
The alternative wash mode stays active until it is deactivated, another wash mode is selected, or the warewasher is
switched off.
Deactivate alternative wash mode
Wash breaks
Ø Do not switch the warewasher off during wash breaks.
6.3 Changing the tank water
Change the tank water if it is very dirty and if the end wash result worsens.
Note:It takes a few minutes until the warewasher is ready for operation again, as the tank is first emptied and
then refilled and reheated.
6.4 Switch off the warewasher
Ø Switch off the warewasher at the end of the working day using the drainage programme so that it is cleaned and emp-
tied every day.