89008157 13
8 Each day after rinsing
8.1 Empty tank; self-cleaning program
Take all cutlery out of the machine.
Close the door.
Press down the function key (2) and hold it down for three seconds to start the self-
cleaning program. The function key will flash.
Now the tank water in the rinsing space will circulate for a while before it is pumped out.
Then the interior of the machine will be rinsed out with fresh, hot water, which will also
be pumped out afterward. When the self-cleaning program is finished, the machine will
switch off automatically. The operating panel will no longer be lit.
Take out the filter cassette and clean it under running water.
Put the filter cassette back in.
Open the door slightly. There is a catch for this purpose in the door latch. This helps the
interior dry out. This is important to prevent rust, even on stainless steel.
8.2 Switching off
When the self-cleaning program is finished, the machine's control will already have switched off automati-
cally. However, the machine is still live.
Close the stop valve on the water supply
1
.
Switch your own main switch off.
Now the machine is no longer live.
1
If a water treatment system is hooked up in front, adhere to the instructions in the documents for this de-
vice.
To Next Page
Loading...
