4 89008157
3 Before using the machine
Before you use the machine in your work, it must be connected on your premises by trained specialists in
conformance with locally effective regulations and then set in operation by the Winterhalter customer service.
3.1 Setup and hookup
Setting up and hooking up the machine to the customer's supply lines and outlets must
be performed in conformance with specific local and national circumstances by ap-
proved fitters.
Completeness check:
After unpacking the machine, first check the delivery against the packing slip to see that it is complete and
has suffered no damage during transportation. Inform the haulage company, the insurance company and the
manufacturer immediately of any damages.
Setting up and aligning the machine
Before beginning installation, use a water level to align the machine horizontally. Use the machine's height-
adjustable feet to even out any irregularities in the floor.
Put the machine without any back paneling up against a wall.
Please note that water vapor escapes from the machine when it is running (for instance, when
the door is opened). Any wooden furniture nearby must be shielded to keep it from swelling.
Do not expose the machine to freezing temperatures. Freezing can damage running water
systems damaged.
Sanitary installations:
Please observe carefully the information in the attached connection diagram!
Make sure that the water pressure and flow capacity demanded by the connection diagram are
present so that the machine will function properly.
• Install an easily accessible main shutoff valve in the water supply line near the machine. It may not
be located behind the machine.
• The machine is DVGW and WRC approved, or designed and built according to DVGW and WRC
guidelines. It can be connected to the fresh water supply line without any safety device in between.
• For the cutlery to dry without spots, the water must be kept as free as possible of salts and minerals.
Its conductivity must be less than 50 µS/cm. The best method of water treatment depends on the qual-
ity of the local water supply. In most cases, however, it will be necessary to desalinate the input water.
Winterhalter will be glad to help you choose a suitable water treatment unit.
• Use the hose and the fine filter in the machine to connect it. The fine filter keeps particles from the
water supply line from getting into the machine and causing extraneous rust to form on the cutlery or
the machine itself.
• The machine is equipped with a drain pump. The maximum draining capacity is found on the connec-
tion diagram.
To Next Page
Loading...
