89008157 15
Put the flat filter with the filter cassette back in.
Put the lower washing fields back in.
If the upper washing arm is particularly dirty:
Take out the upper washing-rinsing system. Loosen the screw with a coin. Rinse the washing arm off with
water.
Check that the nozzles are clean.
Put the washing-rinsing system back in. Tighten the screw again.
FI fault-current circuit-breaker:
Check the FI fault current circuit breaker on your premises regularly according to regula-
tions by pressing the function test knob.
10 Malfunctions
10.1 Malfunctions you can remedy yourself
You can remedy minor malfunctions yourself. See the following table. If you cannot remedy the fault, please
get in touch with the responsible Winterhalter customer service.
Do not open any panels or parts of the machine if you need a tool to do so. You may get an
electric shock.
Only trained specialists are allowed to work on the electrical system. Unplug the machine from
the mains supply beforehand.
Do not switch the machine back on until the cause of the fault has been remedied.
Switch off the main switch on your premises. Only then is the machine no longer live.
Fault Possible cause Remedy
Main switch on your premises is
switched off.
Switch on main switch.
Impossible to
switch machine
on
Defective fuses. Put in new fuses
Door not completely closed Close door completely
Rinsing program
does not start
Machine not ready for operation.
Switch on main switch on your premises, open
water stop valve and switch on machine
To Next Page
Loading...
