16 89008157
Fault Possible cause Remedy
The following ap-
pears on the control
panel:
External water treatment system needs
regenerating
Regenerate external water treatment system
The following ap-
pears on the control
panel:
Too little rinse aid Add rinse aid
The following ap-
pears on the control
panel:
Water stop valve is closed
Malfunction
Switch off machine (press on-off switch). Then
Err will appear on the control panel accompa-
nied by a fault code.
If error code 20 is shown, close the water shut-
off valve and notify Winterhalter customer ser-
vice.
If other error codes are displayed, check
whether the water shut-off valve is opened.
Then switch on the machine again.
If the fault message appears again, note the
fault code and get in touch with the appropriate
Winterhalter customer service
Key flashes blue
If the cutlery has not been properly
cleared away beforehand, so much dirt
may have collected on the flat filter and
in the filter cassette that the rinsing
program can no longer run properly.
The washing pump switches off and the
program key flashes blue.
• Switch off machine, the program key will
continue to flash.
• Take out filters, clean and replace them.
• After two minutes, the flashing will stop.
Switch the machine back on and con-
tinue to run it.
• Clear away the cutlery more carefully to
avoid further malfunctions.
DOS
To Next Page
Loading...
