Winterhalter Gastronom GmbH; Winterhalterstrasse 2-12, 88074 Meckenbeuren; Tel.: 07542-402-0Issued: 12-2016
For conductivity-controlled competitors' dosing units, the following also applies:
The use of conductivity-controlled competitors' dosing units is not appropriate for dishwashing machines
with integrated water softeners, as regeneration salt can enter the tank and cause errors in measured
values.
Open the door and remove the strainer with filter cylinder.
Remove the left side panel.
A hole must be drilled in the tank to install the conductivity electrode. First ensure accessibility for
installation and place rags or suitable paper in the inside of the tank to catch the drilling chips. The
optimum position for the conductivity electrode is shown below and is marked with "C".
The size of the drilled hole depends on the conductivity electrode. The hole must be carefully
deburred before installing the electrode.
Caution: carefully remove drilling chips from the inside area (use vacuum cleaner if
necessary), as these can cause rust to form in the machine's tank and may also block up the
jet systems.
Install the competitor's dosing unit. Any fixtures, mounting equipment etc. must be provided by the
customer.
Powder dosing
For the UC-S, UC-M, UC-L, UC-XL front loading dishwashing machines, there is no suitable point for a
dosing opening for powder dosing. Powder dosing units are therefore not permitted on these machine
types.
To Next Page