Cleaning and maintenance | 8 | English
Operating instructions UC-Serie | 89014383; Version 2 | 45
8.4 Replacing the canister
WARNING
Risk of chemical burns when handling chemicals
Ø Observe the danger and safety notes on the canister and safety data sheet.
Ø Wear protective clothing, protective gloves and protective goggles.
Note:Only for machine with external canisters.
A suction tube is needed to suck out the chemicals from the canisters.
– Do not place the suction tube for the rinse aid in the canister with detergent or vice versa.
– Only use the suction tube with sufficiently stable canisters. Narrow and tall canisters can tip as soon as the suction
tube is pulled.
– Do not pull on the dosing hose or main power cable, as this may lead to a defect.
Ø Wear protective clothing, protective gloves and protective goggles.
Ø Pull the suction tube carefully out of the empty canister.
Ø Check whether both vent holes (1) in the caps are open. Clean if required.
Ø Place suction tube in the new canister.
Ø Slide the cap slowly downwards until the canister opening is closed.
Ø Prime the dosing device.
Priming the dosing devices
The dosing device must be primed if air has entered the dosing hose. This occurs if the canister is not replaced in time.
Item Name
1 Rinse aid dosing device
2 Detergent dosing device
Ø Press button 1 or 2.
ð The button turns white.
ð The dosing device is being primed.
Ø As soon as the button goes off again, exit the menu.
To Next Page
Loading...
