the transmitter will send to the receiver some parameters (frequency, channel,
group and transmitter’s name) and after synchronization, the receiver shows the
name of the transmitter
• RX->TX to set the transmitter at the same frequency of the receiver:
the receiver will send to the transmitter some parameters (frequency, channel,
group and receiver’s name) and after synchronization, the transmitter shows the
name of the receiver (ex. SINGER_1)
If the operation is not possible, (i.e. the frequency range of the transmitter is not compatible with
the frequency of the receiver or vice versa), the display shows an error message.
If the synchronization is successful, the display of the devices shows number of channel and group
or SYNC channel according to the frequency plan memorized on the Wisycom product:
CASE A: if frequency, channel and group are the same in the two devices, channel and group are
also displayed (ex: CH00: 566.000, GR39: Unlock)
CASE B: If frequency, channel & group of the transmitter are different from those of the receiver,
the transmitter shows only the frequency after the word SYNC. (ex: SYNC: 620.000)
Ex: RX->TX
To Next Page
Loading...
