- Transport and storage - 32
6.6 ELECTRICAL INFORMATION
Folgende Vorkehrungen im Steuerstromkreis sind zu berücksichtigen:
6.6.1 Overload protection
An overload protection switch shall protect the pump against too high current (amps) consump-
tion. Maximum setting must be less than max. allowable current I
max
shown on the type plate.
6.6.2 Hand switch
It is recommended the control panel incorporates a H–0-A switch for use during commission-
ing and maintenance operations.
It is important to take care that during manual operation of the pump all safety
devices in the circuit are connected and in good working condition.
The length of the incoming power cables should be of sufficient length to enable the tilting and
moving of the pump during inspection and replacement of the conical strainer in the pump
suction connection.
TRANSPORT AND STORAGE
All connections are protected with yellow plastic caps to prevent any dirt, debris or water con-
taminates the regulator.
Storage shall be dry and protected from any dirt or debris.
Please lift the pumps according to the following photos.
To Next Page
Loading...
