5 - Introduction -
1.3 SAFETY ADVICE
The pump is designed for use in industrial refrigeration systems using primary refrigerants.
It is very important that everybody responsible for the safe operation and
maintenance of the plant reads this manual.
The coupling protection must be in place at all times! (see chapter 8.2.2)
If you have any problems please do not hesitate to call our service department, who will be glad
to assist you.
Make sure the ground area around the pump is clear, e.g. no incoming electric power cables. If
you cannot avoid such obstruction, they should be marked with two-coloured warning tape (warn-
ing sign).
Correctly retighten all screw connections after mainte-nance and repair work.
If you have to disassemble any safety devices for maintenance and repair make sure that upon
completion of said work the re-assembly and correct functioning is checked.
When operating at low temperatures (< 0°C) freeze bites can occur when the surface is touched.
Therefore always wear appropriate protection clothing.
1.4 DISCLAIMER
Even when using the pump for the intended purpose it cannot be entirely excluded that a danger
may remain during its working lifetime.
Translations have been made to the best of our knowledge. We are unable to accept any liability
for er-rors in translation.
We reserve the right to change descriptions, graphs and technical information due to future de-
velopment of the refrigerant pump.
To Next Page
Loading...
