Start-up
11
en
2.4 Rinsing for start-up
> Make sure that the empty pad cartridge has been inserted.
> Turn the adjusting knob B to position z.
> Place a catch basin – with a minimum capacity of 0.5 litres – in the middle underneath all spouts.
> Press one of the cup buttons E or G.
The rinse procedure begins. Do not intervene in the rinse procedure. Do not remove the water tank
and do not unplug the mains plug, as otherwise you will have to restart the start-up.
During start-up, the number of rinse procedures required will be indicated electronically. If more than
one rinse procedure is required, each procedure is terminated after 45 seconds and the ready indicator
F
will flash white again.
> Where necessary, empty the catch basin and press one of the two cup buttons again E or, G
> If you rinsed sufficiently, the ready indicator F will light up red and the water will be reheated
again.
> Turn the adjusting knob B to position |.
Rinse first start-up
To Next Page
Loading...
