WMT CNC210 - Page 21

CNC210 Operating Manual
Tail sleeve lubricating is not in a good condition.
7.5.10 The runout of the tail sleeve center is too large.
A:The tailstock bear a large thrust .
B: The gap between tail stock and tail stock sleeve is to large.
C:The locking handle without locking
7.5.11 The tail stock body can not move.
A:The eccentric lock not loosened.
B:The lubrication of the moving parts is not good.
C:The eccentric locking after released, following plate hit the bed or get stuck.
7.5.12 electrical system and NC system fault
Please see the Electrical manual and NC system manual, driver manual and other
accessories.
Drawing of bed assembly
Parts list
No.
Parts No.
description
Q’ty
1
CNC210-01-001
bed
1
2
GB70-85
Screw M5╳20
4
3
Feed motor
1
4
EKL/20/B/8/8
Elastic coupling
1
5
CNC210-04A-001
Motor seat
1
6
Dental cover nut M10╳1
1
7
CNC210-04-003
Spacer
1
8
GB70-85
Screw M6╳20
4
9
GB118-2000
Taper pin 6╳18
2
10
GB/T292-94
Duplex angular contact bearings in pairs7200C/DB P5
1 set
11
CNC210-04A-007
Spacer
1