CSO24 and CSO30 (SWS #13508346)
Troubleshooting Guides
5-2
#9001333 - Revision A - August, 2014
TROUBLESHOOTING
This section of the manual is divided into five troubleshooting guides and categories (see table of contents below).
Table of Contents
1. Malfunctions with Error Codes .......................................................................................................................... 5-3
2. Malfunctions/Messages Without Error Codes .................................................................................................... 5-9
3. Malfunctions Without Fault Displays//Messages ............................................................................................... 5-10
4. Switching Demo-Modus ON/OFF ...................................................................................................................... 5-10
5. Diagnostic Mode (History and Counters) .......................................................................................................... 5-11
NOTES:
• If the appliance has an error, that error code will appear on the display when it is happening to the appliance
without entering diagnostic mode.
• Though not listed, the cause of all error codes could be the result of, in rare cases, other factors such as:
- Faulty wiring e.g. through a short circuit, break, loose contact, earth contact, etc.
- Problems with the electronics assembly groups, caused by moisture, dirt, component failure, EMC influ-
ences, etc.
• Before continuing, please take note of the WARNINGS and CAUTIONS below.
• TO AVOID ELECTRIC SHOCK, NEVER TOUCH ANY PART OF THE ELECTRICAL CIRCUIT WITH HANDS OR
UN-INSULATED TOOLS WHILE THE POWER IS CONNECTED.
• FAILURE TO INSTALL THE MOUNTING SCREWS CAN ALLOW THE OVEN TO TIP FORWARD DURING USE!
Be careful when handling sheet metal parts - Edges may be sharp.
To Next Page
Loading...
