3 Install the cover over the J-box.
4 Connect the wire harnesses to the power board assembly.
5 Install the four screws holding the power board assembly
case together.
6 Connect the ribbon cable, and close the ribbon cable cover.
7 Connect the wire harness to the control panel.
8 Install the wire cover over the rear of the control panel.
9 Place the control assembly into the unit, so that the buttons
go through the holes in the frame.
10 Use a Phillips screwdriver to install the screws holding the
control assembly to the frame.
PAIR THE REMOTE CONTROL
1 Verify the remote control has new AAA batteries. If not,
replace them.
2 Verify the blower and lights are turned off.
3
Press and hold
on the hood for five seconds.
The LED on the hood flashes twice to indicate that it is
paired.
Wolf V-Series Cooktop Hoods Service Manual
INSTALL THE WIRE HARNESS (continued)
service.subzero.com
825309 REV. B
9
To Next Page
Loading...
