INNER PANEL HINGE INSTALLATION
Install the Inner Panel Hinge
1 Place the frame hinge leaf onto the unit.
2 Use a Phillips screwdriver to install the frame hinge leaf to
the frame.
3 Insert the inner panel hinge leaf into the hinge.
4 Insert the central pin into the inner panel hinge.
SIDE PANEL REMOVAL
Only white glass models have field-replaceable side panels.
Remove the Side Panel
SIDE PANEL INSTALLATION
Install the Side Panel
OUTER PANEL REMOVAL
Remove the Outer Panel
1 Use a Phillips screwdriver to remove the screws around the
outside of the outer panel.
2 Lift the outer panel from the unit.
TIP: The outer panel attaches tightly to the frame. When the
screws are removed, pushing one corner upward can help to
loosen the outer panel.
OUTER PANEL INSTALLATION
Install the Outer Panel
1 Place the outer panel on the unit.
2 Use a Phillips screwdriver to install the screws around the
outside of the outer panel.
MOUNTING BRACKET REMOVAL
Remove the Mounting Bracket
1 Remove the
3
/
8
" screws.
2 Remove the mounting bracket from the unit.
MOUNTING BRACKET INSTALLATION
Install the Mounting Bracket
1 Install the two mounting brackets to the hood using the four
9
/
16
" length screws.
2 To determine the height of the adjustable mounting
brackets, subtract 5" from the support framing height (for
example, in the figure, H = support framing height - 5).
Wolf V-Series Cooktop Hoods Service Manual
service.subzero.com
825309 REV. B
7
To Next Page
Loading...
