What to do if my Wood-mizer BMT300 Industrial Equipment displays 'Error --- A/D A/D Failure'?
If your Wood-Mizer Industrial Equipment displays an 'Error --- A/D A/D Failure', it could be due to a power supply failure, a broken A/D module, or a linear sensor that is out of range. First, check the connecting cable and the A/D module connections. Replace the module if necessary. Then, adjust the linear sensor.
Why does my Wood-mizer BMT300 show 'Error --- IDX Home Sensor'?
The 'Error --- IDX Home Sensor' on your Wood-Mizer Industrial Equipment may be caused by a circuit breaker failure, an improperly adjusted proximity sensor, or an unplugged index motor. Check the 3 Amp circuit breaker located at the rear of the setter; turn it on or replace it if necessary. Adjust the proximity sensor and ensure the indexer motor is plugged in.
What to do if Wood-mizer BMT300 displays 'Error --- CAM Home Sensor'?
If your Wood-Mizer Industrial Equipment displays 'Error --- CAM Home Sensor', the cause may be a circuit breaker failure, an improperly adjusted cam proximity sensor or an unplugged cam motor. Check the 3 Amp circuit breaker located at the rear of the setter. Reset the circuit breaker or replace it if necessary. Adjust the cam proximity sensor, ensuring the proximity sensor light is on. Plug in the cam motor.
What to do if Wood-mizer BMT300 Industrial Equipment displays 'Error --- Cal Sensor Out of Range'?
If your Wood-Mizer Industrial Equipment displays 'Error --- Cal Sensor Out of Range', it indicates that the linear sensor is out of range. Adjust the linear sensor.
What does 'Error --- IDX Not Fully Seated' mean on my Wood-Mizer Industrial Equipment?
The 'Error --- IDX Not Fully Seated' on your Wood-Mizer Industrial Equipment means the indexer is not seated properly, and the proximity sensor light is off. To resolve this, adjust the indexer assembly and check if the proximity sensor light is on.
Why does my Wood-mizer BMT300 show 'Error --- Bld Tooth Set'?
The 'Error --- Bld Tooth Set' on your Wood-Mizer Industrial Equipment indicates that the tooth set is incorrect. To fix this, adjust the pusher and inspect the blade.
What to do if Wood-mizer BMT300 displays 'Error --- Cal Clamp Zero CAL Block'?
If your Wood-Mizer Industrial Equipment displays 'Error --- Cal Clamp Zero CAL Block' while calibrating, it means the metal pattern block is not clamped. Clamp the metal pattern block to adjust the sensor pin.
What does 'Error -- Sensor Return Zero' mean on my Wood-mizer BMT300 Industrial Equipment?
The 'Error -- Sensor Return Zero' on your Wood-Mizer Industrial Equipment indicates that the sensor pin is stuck. Inspect the sensor pin and clean it if necessary.
What does 'Error --- Bld Set Pattern' mean on my Wood-Mizer Industrial Equipment?
The 'Error --- Bld Set Pattern' on your Wood-Mizer Industrial Equipment means the tooth set pattern is not correct. Inspect the blade teeth and correct the teeth pattern.
What to do if my Wood-mizer BMT300 Industrial Equipment displays 'Lower Set Limit >= Upper Set Limit'?
If your Wood-Mizer Industrial Equipment displays 'Lower Set Limit >= Upper Set Limit', it means the lower tooth set limit is above the upper limit. Increase the upper tooth set limit, or decrease the lower tooth set limit.
General| Max Log Diameter | 36 inches |
|---|---|
| Throat Opening | 36 inches |
| Blade Width | 1.5 inches |
| Optional Features | Debarker |
| Voltage | 220V |
To Next Page