What to check if Genset is running while ATS not transfer with Woodward Controller?
If the genset is running but the ATS isn't transferring with the Woodward Controller, check the ATS and the connections between the ATS and the controllers.
What to do if Woodward Control Systems fail to start?
If the Woodward Control Systems fail to start, check the fuel oil circuit and its connections, verify the starting batteries, and inspect the speed sensor and its connections. Also, refer to the engine manual.
What to do if Woodward Control Systems controller has no power?
If the Woodward Control Systems controller has no power, check the starting batteries, inspect the controller connection wiring, and check the DC fuse.
What to do if Woodward Control Systems ECU communication failed?
If the Woodward Control Systems ECU communication failed, check the CAN connections for high and low polarity, verify if the 120 ? resistor is connected properly, check if the type of engine is correct, and see if the connections from the controller to the engine and the output ports settings are correct.
What to do if Woodward Control Systems starter no response?
If the Woodward Control Systems starter gives no response, check the starter connections and inspect the starting batteries.
How to handle ECU warning or shutdown on Woodward easYgen-1800 Control Unit?
To address an ECU warning or shutdown on the Woodward Control Unit, get information from the alarm page's LCD. If there is a detailed alarm, check the respective engine. If there is no detailed alarm, please refer to the relevant section of the engine manual as specified in the SPN alarm code.
What to do if shutdown alarm in running on Woodward Control Unit?
If the Woodward Control Unit displays a shutdown alarm while running, check the switch and its connections according to the information on the LCD and check auxiliary input ports.
How to troubleshoot Woodward easYgen-1800 Control Unit with no power?
If the Woodward Control Unit has no power, check the starting batteries, the controller connection wiring, and the DC fuse.
What to do if Woodward Control Systems low oil pressure alarm after crank disconnect?
If the Woodward Control Systems triggers a low oil pressure alarm after crank disconnect, check the oil pressure sensor and its connections.
What to do if Woodward Control Systems ECU warning or shutdown?
If the Woodward Control Systems ECU displays a warning or initiates a shutdown, get information from the LCD of the alarm page. If there is a detailed alarm, check the respective engine. If there is no detailed alarm, please refer to the relevant section of the engine manual as specified in the SPN alarm code.
General| Power Supply Voltage | 24 VDC |
|---|---|
| AC System | 1-phase, 2-wire |
| Operating Temperature | +70 °C |
| Operating Temperature Range | -40°C to +70°C |
| Communication Ports | RS-485 |
| Communication | Modbus RTU |
| Protection Class | IP20 |
| Supported Protocols | Modbus RTU |
To Next Page
