What to do if Woodward Control Systems fail to start?
If the Woodward Control Systems fail to start, check the fuel oil circuit and its connections, verify the starting batteries, and inspect the speed sensor and its connections. Also, refer to the engine manual.
What to do if Woodward Control Systems controller has no power?
If the Woodward Control Systems controller has no power, check the starting batteries, inspect the controller connection wiring, and check the DC fuse.
What to do if Woodward Control Systems ECU communication failed?
If the Woodward Control Systems ECU communication failed, check the CAN connections for high and low polarity, verify if the 120 ? resistor is connected properly, check if the type of engine is correct, and see if the connections from the controller to the engine and the output ports settings are correct.
What to do if Woodward Control Systems starter no response?
If the Woodward Control Systems starter gives no response, check the starter connections and inspect the starting batteries.
How to handle ECU warning or shutdown on Woodward easYgen-1800 Control Unit?
To address an ECU warning or shutdown on the Woodward Control Unit, get information from the alarm page's LCD. If there is a detailed alarm, check the respective engine. If there is no detailed alarm, please refer to the relevant section of the engine manual as specified in the SPN alarm code.
What to do if shutdown alarm in running on Woodward Control Unit?
If the Woodward Control Unit displays a shutdown alarm while running, check the switch and its connections according to the information on the LCD and check auxiliary input ports.
How to troubleshoot Woodward easYgen-1800 Control Unit with no power?
If the Woodward Control Unit has no power, check the starting batteries, the controller connection wiring, and the DC fuse.
What to do if Woodward Control Systems low oil pressure alarm after crank disconnect?
If the Woodward Control Systems triggers a low oil pressure alarm after crank disconnect, check the oil pressure sensor and its connections.
What to do if Woodward Control Systems ECU warning or shutdown?
If the Woodward Control Systems ECU displays a warning or initiates a shutdown, get information from the LCD of the alarm page. If there is a detailed alarm, check the respective engine. If there is no detailed alarm, please refer to the relevant section of the engine manual as specified in the SPN alarm code.
What to do if Woodward Control Systems high water temp. alarm after crank disconnect?
If the Woodward Control Systems triggers a high water temperature alarm after crank disconnect, check the temperature sensor and its connections.
General| Power Supply Voltage | 24 VDC |
|---|---|
| AC System | 1-phase, 2-wire |
| Operating Temperature | +70 °C |
| Operating Temperature Range | -40°C to +70°C |
| Communication Ports | RS-485 |
| Communication | Modbus RTU |
| Protection Class | IP20 |
| Supported Protocols | Modbus RTU |
Manual overview, revision history, and notes.
Includes general information, copyright, and disclaimer details.
Information on service, warranty terms, and potential voidance.
Covers general safety guidelines and intended application of the device.
Defines the proper and intended application of the easYgen unit.
Lists the various status screens available on the Human Machine Interface (HMI).
Details status information accessible via the ToolKit-SC software.
Describes the buttons, indicators, and display on the controller's front panel.
Explains how warnings and alarms are visualized using LEDs and horns.
Outlines the three main operation modes: AUTO, MANUAL, and STOP.
Covers the procedures for starting and stopping the genset.
Lists and explains all alarms and warnings generated by the controller.
Lists alarms that cause the generator to shut down.
Lists alarms that cause a trip and stop condition for the generator.
Lists alarms that cause a trip condition without stopping the generator.
To Next Page
