USER INSTRUCTIONS & CUSTOMER CARE GUIDE
OPERATING THE APPLIANCE
8-716-106-255a (03.05)
OPERATING THE APPLIANCE
3
FAULT CONDITIONS:
The 'Demand' and 'Lockout' lights can indicate some
basic fault conditions:
-4#$-5#&!-%(
#64#%7$!8)&(
Light ON; demand for heat from the heating/hot
water system
Light OFF; boiler not firing, no demand from
heating/hot water system
4#%7#%7-"-+&$!8)&'(
96
-&)$!8)&':9-!$%-&;!!%8<
1 Check the oil level in the oil storage tank
2 Press reset button (E). Boiler should fire
3 If no response, wait 2 minutes - press reset
button (E) again
4 If lock out light stays on, do not attempt further
resets. Contact your service engineer for advice.
c)
-&)$!8)&':9-!$%-&-%:%-)#&!%8=)-&
>#&<
1 Ensure there is a power supply to the boiler
2 Check the programmer is set to on
3 Press reset buttons (F) for heating
4 If the demand light remains off, contact your
service engineer for advice.
ACCESSING RESET BUTTONS:
PULL BOTTOM OF
FRONT PANEL OUT AND
LIFT TO REMOVE
a)
b)
c)
To Next Page
Loading...
