5
LS-Node
Sección 1: Introduction
1.1 Safety Instructions
Please read the following Safety Notes carefully before starting to work with the product.
These notes include important safety information about installation, use, and maintenance.
• Before using this product, carefully read the instruction manual and keep it for future
reference.
• You must use a power supply according to the voltage marked on the rear panel, you
will void the warranty in case of using an inadequate voltage.
• Before connecting the device to the electric outlet ensure that the power cord is not
damaged.
• Always connect the device to the power supply supplied in the box.
• Install the device in a at and stable location.
• This product is rated IP20 so do not install near water or wetness, it is for indoor use
only.
• Place the device away from heat sources such as radiators. Make sure there are no
ammable materials near the device when it is in operation.
• Never connect the device to an electrical regulator or rheostat.
• To prevent the risk of shock, do not open or disassemble the unit.
• Never pull the power cord to turn off the device.
• If you install the device at a high place, please make sure that the bracket is properly
xed and secured.
• Equipson SA will not accept any liability for damage caused by unauthorized
modications or improper use of the device.
• If the device needs repair, contact Equipson SA or an authorized distributor.
To Next Page
Loading...