7.
Setting Up
Installing The Battery
This product is supplied with a 9V battery. To t the battery please remove the
battery from it’s wrapper. Open the battery bay by pushing the tab towards the
top of the detector on the battery cover and lifting the cover up.
Connect the 9V battery to the correct terminals and place it in the battery bay.
Replace the battery cover by inserting the holding pins rst at the top of the bay
and closing the cover down so the tab locks in to place.
Turning On/Off
To turn the Stud Detector on or o, give the ‘On/O’ button a quick press. If the
Stud Detector is left unused for 3 minutes, it will turn itself o.
To Next Page
Loading...
