9.
Operating
Stud Scanning Mode
To scan for studs make sure the detector has been set to one of the rst three
settings and calibrated as mentioned on page 7, place the detector’s back at
against the surface you want to scan. In a slow paced motion move the detector
up right across the surface in the direction you want to scan.
When you are close to a stud there will be an
arrow point the direction of an object
detected. Move slowly in the direction
indicated. The center levels bar will rise or
lower depending on how close you are to an
object.
As soon as the detector shows a line next
to the arrow you will have found edge of the
stud. Use the ‘V’ groove to mark the centre
of the stud with a pencil if required.
To Next Page
Loading...
