WBJ-900www.servotool.eu0203-5142281
GB
1800-719901
IRL
AFTER SALES SUPPORT
Adjusting the cutting depth
Fig.A
• Movethemotorbaseasfaraspossiblebackwards.
• Setthecuttingdepthbyturningthecuttingdepthadjustmentknob(6).
• Movethemotorbaseforwardsandcheckifthepinwillfallinthenotchofthe
adjustment knob.
The following table shows the relationship of the markings on the adjustment knob
to cutting depth, thickness of material and associated biscuit dowel.
Marking Thickness of material Biscuit dowel Cutting depth in mm
0 0 - 12 mm No. 0 8.0
10 12 - 15mm No. 10 10.0
20 >15 mm No. 20 12.3
M - - 19.0
Adjusting the cutting angle
Fig. A
• The cutting angle can be set by unlocking the Angle adjustment knob (7) and put
the angle stop (4) in the required angle.
Adjusting the height
Fig. A
• The correct height can be set by turning the knob for the height adjustment (8) to
the desired height with aid of the scale (9).
• The height must corresponds to half of the material thickness of the working piece,
the groove for the biscuit dowel must always be in the middle of the working piece.
Prior to mounting an accessory always unplug the tool.
Mounting the saw blade
Fig. B
• Loosen the allen screw with the supplied allen wrench and open the top of the base
plate.
• Press the spindle lock and turn the spindle until it engages in the lock. Keep the
spindle lock pressed during this procedure.
• Remove the flange nut from the spindle using the wrench.
• Position the saw blade on the flange.
• Be aware that the arrow on the sawblade indicates the same direction as the arrow
on the inside of the housing.
• Place the flange nut on the spindle and tighten it with the wrench.
• The flange nut has two sides. One for sawblades with bore 20 mm and the otherside
for sawblades with bore 22 mm. Take care that the flange nut will be placed with
the correct side on the spindle.
BJM6003 Ma EN-IRL 1202-22.indd 13 2/22/12 4:26 PM
To Next Page
Loading...
