WBJ-900www.servotool.eu0203-5142281
GB
1800-719901
IRL
AFTER SALES SUPPORT
• Persons under 16 years of age are not permitted to operate this machine.
• Always wear safety goggles and hearing protection. If desired or required also use
another protection for example an apron or helmet.
• Always disconnect the plug from the socket before carry out any work on the
machine. Only plug-in when the machine is switched off.
• Keep mains lead clear from working range of the machine. Always lead the cable
away behind you.
• Do not stop the blade by hand after switching off.
• The base plate must not be clamped down while the blade is extended. Lowering
and raising the blade must be a smooth operation.
• Always use the protective shields on the machine.
• Use only cutting discs whose allowable speed is at least as high as the highest noload
speed of the machine.
Electrical safety
Always check that the voltage on the machine corresponds to the voltage on the
rating plate. Also check that your mains voltage corresponds to the input voltage
of the battery charger.
The machine is double insulated; therefore no earth wire is required.
• Do not use the machine if the mains cable or the mains plug is damaged.
• Only use extension cables that are suitable for the power rating of the machine with a
minimum thickness of 1.5 mm
2
. If you use an extension cable reel, always fully unroll
the cable.
Mains plug replacement
If the moulded 3-pin plug attached to the unit is damaged and needs replacing, it is
important that it is correctly removed and replaced by an approved BS 1363/13A fused
plug and that the following wiring instructions are followed.
The wires in the mains cable are coloured in accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of the unit may not correspond to the
coloured markings identifying the terminals in the plug, proceed as follows:
• The wire which is coloured blue must be connected to the terminal which is marked
with the letter N or coloured black.
• The wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
BJM6003 Ma EN-IRL 1202-22.indd 7 2/22/12 4:26 PM
To Next Page
Loading...
Need help?
General
