Landing
Return Home
50 Feet
Pressing once will make Recon autonomously land at its current spot. The
drone may bounce a few times when landing, this is normal. The rotors will stop
rotating 5 seconds after landing on the ground.
During auto landing, you can use the joystick to reposition the drone if the landing
area is not flat or safe.
If the drone is lower than 50 feet in the air, pressing and holding will make
the drone autonomously fly to 50 feet, slowly fly back to the take off point and land.
If the drone is higher than 50 feet it will maintain current height and slowly fly back
to the take off point and land.
If there is an obstacle in the way of returning home, you can still use the joystick to
adjust the positioning of the drone to return safely.
Land (press once)
Return Home (press and hold)
To Next Page
Loading...
Need help?
General
