HANGZHOU WORLDE DIGITAL PIANO CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:SALES@WORLDE.COM.CN TEL:86 571 88730848
- 8 -
Octave button one time will change 1 Octave of the keyboard. The farther from center the keyboard has been transposed,
the faster the buttons will flash.
To reset the keyboard octave range back to center, press both buttons at the same time. Factory default range is C3-C5.
Octave buttons
3.1.6 Parameter control encoders
The 8 encoders can be assigned to control any editable parameter on the selected device. Use the WORLDE software
editor to edit the parameters. If your DAW can recognize the standard 128 midi controller, you only need to assign the
knobs to the controller No. as required. For example, No.7 is the volume controller in MIDI standard, so if you want to use
Knob1 as volume control, you should assign CC No.7 to Knob1 with WORLDE software editor, then the Knob1 will control
the volume of your DAW. Standard MIDI CONTROLLER PARAMETER LIST can be found in the Appendix.
The Parameter control encoders
3.1.7 The pads/preset buttons
The eight large buttons of the TUNAMINI serve a dual purpose. Their exact duties are determined by the state of the Shift
and Pads buttons.
For example: The pads can be assigned to trigger up to sixteen particular MIDI notes (drums, stabs, bass notes, whatever).
When the Pads 1-8/9-16 button is not lit, the first bank of pads is active (1-8) which will send notes message at this
moment. The 8 pads are just 8 keys now. Use the WORLDE TUNAMINI software editor to edit the key value for each pad.
The default is sending the note message on Channel10. When the Pads 1-8/9-16 button is lighting, the second bank of
pads is active (9-16) whose default is to send CC No. so the pads won’t produce any sound when pressed in this mode.
However, when used in conjunction with the Shift button, the pads will recall one of eight MIDI presets. This is
accomplished by holding the Shift button and pressing one of the pads. For example, if you hold the shift button and press
Pad1 the bank1 will be recalled.
The pads/ preset buttons
3.1.8 Parameter control sliders
The 8 sliders can be assigned to control any editable parameter on the selected device. Use the WORLDE TUNAMINI
software editor to edit the parameters. If your DAW can recognize the standard 128 midi controller, you only need to assign
To Next Page
Loading...
