15
EN
Why connect Landroid
Landroid is an IoT (Internet of Things) device. To get full functionality out of your
Landroid and keep it always updated to the latestsoftware, it must be connected to the
internet via your Wi-Fi network.
5.1 BEFORE YOU START
5.1.1 Download the app
Download the free Landroid app first. Get it from Android or Apple app stores
5. CONNECTING LANDROID TO THE INTERNET
Press until Landroid turns on. Input the default PIN code 0000 by pressing
for four times when the number 0 is blinking.
Only for reference
When your landroid is connected with charing base, press three times. Choo-
se by pressing or ,and press ( Figure 1 ).Next, choose
to do boundary cutting or choose not to do boundary cutting by
pressing or ,and press (figure 2) .Then the screen will display
press or to select working time of the day and press to start
(Figure 3).
Note: Landroid will go back to the charging base for charging when the battery
runs out or the cutting time is up .If Landroid is fully charged and the set time has
not ended, Landroid will continue mowing until the time is over.
When your landroid is disconnected with charing base, press three times
.Choose when your landroid is in main area or choose
when your landroid is in secondary area by pressing or ,and press .
(Figure 4 ). Then the screen will display , press or to select
working time of the day and press to start ( Figure 5).
Note : When your landroid is in main area, it will go back to the charging base
for charging when the battery runs out or the cutting time is up .If Landroid is fully
charged and the set time has not ended, Landroid will continue mowing until the
time is over. When your landroid is in secondary area ,it will stop mowing and stay
in the place when the battery runs out, the cutting time is up, landroid encounters
some troubles (e.g. crashing etc.)or “STOP” is pressed manually.
Only for reference
Only for reference
Figure 1 Figure 2
Figure 3
Figure 5
Figure 4