Need help?Do you have a question about the Worx ME1 and is the answer not in the manual?
Visually inspect interior and remove interfering items before operation.
Disconnect power and air source before performing maintenance procedures.
Keep hands clear of moving doors and remove items not to be marked during operation.
Machine can be stopped immediately by pressing the red emergency stop button.
Removing side panels disables the laser; acknowledgment required to re-enable.
Overview of the ME1 laser enclosure and its compatibility with Keyence laser markers.
Details about machine labels and their warnings, including laser radiation.
Identifies and describes key components of the ME1 laser enclosure.
Step-by-step instructions for installing the Keyence laser markers into the ME1 enclosure.
Procedure to adjust the laser head plate to be level with the working surface.
Instructions for connecting and wiring the Keyence laser controller to the ME1 enclosure.
Detailed wiring diagram for connecting the ML-Z laser controller.
Detailed wiring diagram for connecting the MD-X/F laser controller.
Procedure for inserting the laser USB into the Keyence controller.
Instructions for connecting and wiring the Fumex to the ME1 enclosure.
Steps to power on and launch the Worx ME1 application.
Procedure to recover the machine after an emergency stop activation.
How to manually operate the enclosure door using the brake release button.
Step-by-step instructions for safely removing the front door of the enclosure.
Table of recommended daily and weekly maintenance procedures.
Procedure to test the functionality of the Emergency Stop button.
To Next Page
General