13. Using the diagrams below, move the unit slightly to find the matching hole-pattern for your
marking system.
14. Install the provided SHCS M6 x 25mm, four for the MD-F and ML-Z; six for the MD-X,
through the mounting plate into the appropriate hole pattern in the laser marking head base.
15. Securely tighten screws, after all have been started, into the base of the laser marking head.
16. Remove any loose items from the inside of the enclosure.
17. From the rear of the enclosure unit, identify the marking system cables connecting the
marking head to the controller.
To Next Page
Loading...