How to fix Worx Trimmer when command feed does not work?
If the command feed on your Worx Trimmer isn't working, it might be because the cutting line isn't wound well, so rewind the line properly. Also, check for tangles in the line and clear them. If the line is used up, replace it.
Why is my Worx WG163.1 Trimmer not working?
If your Worx Trimmer isn't working, there are several potential causes. First, the battery might be discharged, so try charging it. If the battery is either too hot or too cold, allow it to reach a suitable temperature. It's also possible that the motor is broken, in which case it should be serviced. Finally, damaged internal wiring could be the culprit, requiring inspection and repair.
What to do if command feed does not work on Worx Trimmer?
If the command feed isn't working on your Worx Trimmer, it may be because the cutting line isn't wound well; rewind it properly. Another reason could be that the line is tangled, so untangle it. Finally, the line might be used up, requiring you to replace the cutting line.
What to do if my Worx WG163.1 does not cut?
If your Worx Trimmer isn't cutting, start by checking the cutting line. If the line is broken, replace it. Also, ensure the battery is fully charged. Clear away any grass entangled around the cutting head.
Why Worx WG163.1 cutting time per battery charge is too short?
If your Worx Trimmer isn't running as long as it should on a single charge, there are a few potential reasons. First, if the battery hasn't been used for a while or has only been charged briefly, try fully charging it before use. Also, very high grass can drain the battery quickly, so trim the grass to a shorter length. Finally, the battery itself might be defective and need replacement.
What to do if the battery charge indicator on Worx WG163.1 does not light up?
If the battery charge indicator on your Worx Trimmer isn't lighting up, make sure the charger is plugged in properly and check the socket outlet and cables.
Why is the battery charge indicator continuously lighting on Worx Trimmer and no charging possible?
If the battery charge indicator is continuously lit and you can't charge your Worx Trimmer, first ensure the battery is properly inserted. Also, check the battery contacts and clean them if they are contaminated.
Why is the battery life so short on my Worx WG163.1?
If the cutting time per battery charge is too short on your Worx Trimmer, it could be due to a few reasons. If the battery hasn't been used for a long time or has only been charged for a short term, follow proper battery maintenance guidelines. Also, if the grass is too high, cut it to a more manageable height. Finally, the battery itself might be defective and need replacement.
Why does my Worx WG163.1 Trimmer run intermittently?
If your Worx Trimmer runs intermittently, the battery may not be fully charged; ensure you charge it fully. Alternatively, the On/Off switch could be defective and needs replacing. A broken motor could also cause this issue, requiring servicing.
How to reduce excessive vibration and noise from my Worx WG163.1?
Excessive vibrations or noise from your Worx Trimmer can be caused by a defective machine, which requires inspection and service. Another possible reason is that the line spool isn't wound well, so rewind the line properly.
General| Power Source | Battery |
|---|---|
| Voltage | 20V |
| Battery Type | Lithium-Ion |
| Weight | 5.3 lbs |
| Line Feed | Automatic |
| Cutting Width | 12 inches |
| Line Diameter | 0.065 inches |
| Type | String Trimmer |
To Next Page
