16
Cordless Grass Trimmer
EN
Your power tool requires no additional lubrication or maintenance. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place, and out of the reach of children. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
For Battery tools
The ambient temperature range for the use and storage of tool and battery is 0
o
C-45
o
C.
The recommended ambient temperature range for the charging system during charging is 0
o
C-40
o
C.
7.TROUBLESHOOTING
The following table gives problems and actions that you can perform if your machine does not operate
correctly. If these do not identify and correct the problem, contact your WORX Customer Service at 1-866-354-
WORX.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
Problems Possible Causes Corrective Action
Trimmer fails to
operate.
Battery discharged.
Motor is broken.
Internal wiring of machine damaged.
Recharge battery; also see
the content in charger manual
Contact Service Agent.
Contact Service Agent.
Trimmer runs
intermittently.
Motor is broken.
Battery not fully charged.
Contact Service Agent.
Recharge battery.
Contact Service Agent.
noise.
Machine defective.
Line spool is not wound well.
Contact Service Agent.
Rewind the line. See “MANUALLY
WINDING THE LINE” (Fig. O1, O2, O3,
O4).
Cutting time per
battery charge
too short.
Battery has not been used for long period or
only charged for short term.
Grass too high.
Battery defective.
Recharge battery; also see
the content in charger manual.
Cut in stages.
Replace the battery.
Machine does not cut.
Line broken.
Battery not fully charged.
Motor is broken (speed is too low).
Grass entangled around cutting head.
Replace the line
Recharge battery; also see
the content in charger manual.
Contact Service Agent.
Remove grass.
Continuous lighting
of the battery charge
indicator.
No charging procedure
possible.
Battery not (properly) inserted.
Battery contacts contaminated.
Battery defective.
Properly insert battery into battery
charger.
Clean the battery contacts or replace the
battery.
Replace the battery.
Battery charge
indicator does not
light up.
Plug of battery charger not plugged in
(properly).
Socket outlet, mains cable or battery charger
defective.
Insert mains plug (fully) into the socket
outlet.
Check the mains voltage; have
the battery charger checked by an
authorized after-sales service agent.
Command feed does
not work
Cutting line is not wound well.
The line is tangled.
Line is used up.
Manually feed the line, if still cannot feed
out, remove the Spool out and rewind
the line.
Replace with a new spool of line.