29
• When using this machine with the
Extension Pole, make sure that
attaching the power cord of the
machine to the power cord of the
extension pole, and then attach the
power cord of the extension pole to
power supply.
ELECTROCUTION HAZARD
Never use the Jawsaw
TM
or Extension
Pole in an area with overhead power
lines or where the branch being cut can
come into contact with overhead power
lines.
CUTTING WITH SHOULDER STRAP
(WHEN USED WITH OPTIONAL POLE
ATTACHMENT) (SEE FIG. U5)
The Extension Pole is supplied with a
shoulder strap that gives extra support when
hoisting the Jawsaw
TM
in the air. Hook the
shoulder strap to the Extension Pole and wrap
around your shoulder. The shoulder strap
can also soften the impact if the Jawsaw
TM
is
dropped after the completion of a cut.
CUTTING WITH EXTENSION POLE
(WHEN USED WITH OPTIONAL POLE
ATTACHMENT)
1. Attached the Extension Pole as described
in ‘’Assembling the extension pole’’.
2. Connect the Jawsaw
TM
to extension cord.
Connect extension cord to power supply.
NOTE: The Jawsaw
TM
is quite heavy on the
end of the Extension Pole.
Add the Extension Pole attachment when
cutting limbs above shoulder height and
remove the polen when cutting limbs at or
below shoulder height.
3. Lift Jawsaw
TM
with Extension Pole upward
one step by one step (See Fig. V). To raise
to the vertical position, lift by the Jawsaw
TM
first, then hand over hand along the pole.
4. Before cutting a high branch, consider all
the same points detailed in the previous
section “Trimming Branches” but pay
particular attention to the likely path of the
falling branch.
WARNING: Do not stand directly
below a branch being cut. Keep
bystanders far away. Do not stand on a
ladder or other type of unstable support
while using the tool. Do not use the tool
near cable, electrical power or telephone
lines. Keep 3m away from all power
lines. (See Fig. W1-W4)
5. Position the Jaw perpendicularly on the
branch being cut.
Note: Maximum cutting capacity of
Jawsaw
TM
is 100mm.
6. One hand should firmly grip the push
handle of the Extension Pole. The other
hand should hold the metal portion of the
pole or the sliding handle on the pole (See
Fig. X).
7. Complete the cut as described in
“Trimming Branches”.
8. At the completion of the cut, be ready to
immediately support the weight of the
entire tool as the branch falls.
WARNING: Do not let the
Jawsaw
TM
fall to the ground at the
completion of the cut, this may damage
the tool.
SAW MAINTENANCE AND
KICKBACK SAFETY
Follow maintenance instructions in this
manual. Proper cleaning and maintenance
of the Saw Chain (11) and Guide Bar (10), as
well as the Jawsaw
TM
in general, can reduce
chances of kickback. Inspect and maintain saw
after each use. This will increase the service
life of your saw.
Note: Even with proper sharpening, risk of
kickback can increase with each sharpening.
MAINTENANCE AND
STORAGE OF JAWSAW
TM
1. Unplug the Jawsaw
TM
from power source:
• When not in use.
• When transporting.
• When left unattended.
• Before servicing.
• Before fitting the Extension Pole.
• Before cleaning.
• Before changing accessories or
attachments, such as Saw Chain and
Guard Bar.
To Next Page
Loading...
Need help?
General
