14
SYMBOLS
INTENDED USE
The chain saw is intended for sawing of trees,
tree trunks, branches, wooden beams, planks,
etc. Cuts can be sawed with or across the
grain. This product is not suitable for sawing
mineral materials.
ASSEMBLY
WARNING! Before touching
the chain or making any other
adjustments, make sure that the tool is
switched off and the battery is removed.
Always use gloves when handling the
chain.
CHAIN AND GUIDE BAR ASSEMBLY
1. Unpack all parts carefully.
2. Place the chain saw on any suitable flat
surface.
3. Use only genuine WORX chains designed
for chainbar.
4. Slide the Chain (8) in the slot around the
Guide Bar (7). Ensure the Chain is in correct
running direction by comparing it to the
Chain Direction Symbol (13) found on
the saw body (See Fig. B). Ensure the Bar
Tensioning Plate (17) is facing outward.
(See Fig. A)
5. Fit the Chain onto the Drive Sprocket
(12), so that the Fastening Bar Bolt (16)
and the two Bar Locating Tabs (14) on the
Bar Clamp (20) fit into the keyway of the
opening on the Guide Bar (7). (See Fig. B)
6. Check to see if all parts are seated properly.
(See Fig. C)
7. Fit the Chain Cover (11), ensure that the
Chain Catch (19) slides properly into the
Chain Cover (11). (See Fig. D)
8. Tighten the Chain Cover (11) by turning the
Chain Tensioning Knob (10) clockwise until
it is tight. (See Fig. E)
WARNING: The chain is not yet
tensioned. Tensioning the chain
applies as described under “Tensioning
chain”. The chain now needs to be
inspected to make sure it is properly
tensioned.
WARNING
To reduce the risk of injury, user
must read instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Do not expose to moisture.
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return
exhausted batteries to your local
collection or recycling point.
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
To Next Page
Loading...
