Worx WG368E - Page 20

20
Cordless Chain Saw WG368E WG368E.9
performing any service or maintenance on this tool.
NOTE: It is not necessary to remove the chain or bar
when lubricating the sprocket.
1. Clean the bar and sprocket.
2. Using a grease gun, insert the tip of the gun into the
lubrication hole and inject grease until it appears at
the outside edge of the sprocket tip. (See Fig. X)
3. To rotate the sprocket release the chain stop and pull
the chain by hand until the ungreased side of the
sprocket is in line with the grease hole. Repeat the
lubrication procedure.
CLEANING/STORAGE
Clean the moulded plastic housing of the chain saw
using a soft brush and clean cloth. Do not use water,
solvents or polishes. Remove all debris, especially from
the motor cooling vents.
Remove and brush clean the cover plate, chain and
chain bar after 1 to 3 hours of use. Clean the area
under the cover plate, the drive sprocket and chain bar
assembly using a soft brush. Clean oil outlet with a
clean cloth.
If the chain saw is to be stored for a longer period of
time, clean chain and chain bar.
Store in a secure, dry place out of the reach of children.
Do not place other objects on the chain saw.
To prevent leakage ensure machine is left in a horizontal
position (oil filler cap 4 uppermost).
When storing machine in original packaging the oil tank
must be completely emptied.
1
2
1/3
2/3
2
2/3
1
1/3
2 2
W
Y
Z
X
50 mm
50 mm
1
1
1
Z
Y
kg
Z
Y
a
a
K
L
M
N
O
P
Q
R
S
T
W
X
U
V