Worx WG794E User Manual

Lawn Mowing Robot EN
13
4.3 Joining the Boundary Wire
The Boundary Wire (21) can be extended simply by splicing the ends
and connecting it to the ends of another piece of wire. You can use
insulating tape to secure the joined part of the wire. (See Fig. I)
4.4 Turn on and test installation
If the charger light does not come on, then check the power
connections.
If the charger base LED is flashing green, check if the boundary wire
is connected correctly.
Red light on: charging.
Red light flashing: error message, refer to Trouble Shooting and
correct the problems.
Green light flashing: check if the boundary wire is connected correctly.
When the green light on the charging base is on, place your Landroid
®
M over the boundary wire, if Landroid
®
M follows the
boundary it is connected correctly.
If your Landroid is inside its territory but the display says “out of cutting area” ,and the charger base LED is green, it means
you clamped the boundary wire ends incorrectly. Just reverse them.
5. Maintenance
Your Landroid
®
M needs to be checked from time to time. The Landroid
®
M works hard and after time needs a good
cleaning as well as having some parts replaced, as they can become worn.
In the following we want to let you know how to take care of your Landroid
®
M.
5.1 Keep it sharp
WARNING: Before cleaning, adjusting, or replacing the Blades, turn your Landroid
®
M OFF by
pressing the ON/OFF Button to OFF and put on protective gloves.
WARNING! When fitting new blades, make sure you replace ALL the blades. Always use new
screws when fitting blades . This is important to ensure blade retention. Failure to use new
screws could cause serious injury.
The Landroid
®
M does not cut grass like other mowers. Its
Cutting Blades (14) are razor sharp on all 4 edges and spin in
both directions for maximum cutting capacity (See Fig. J ). Each
blade of your Landroid
®
M has 4 cutting edges. Depending on the
frequency the Landroid
®
M mows your lawn, the cutting blades will
need to be flipped/rotated periodically for a new cutting edge. If
your Landroid
®
M is programmed to mow the lawn every day then
the cutting blades will need to be rotated monthly for the best
mowing results. Each cutting blade will last up to 4 months when
it is programmed to mow every day. When the cutting blades are
dull and worn out, they should be replaced with the spare blades
provided with your Landroid
®
M. Spare blades are also available at
your nearest WORX retailer.
A. Rotate and flip the blades
Your Landroid
®
M carries 3 Blades that are all screwed onto your its Blade Turning Disc (13). The Blades are what let the
Landroid
®
M do its job and need care and attention. Every once in awhile, you should simultaneously rotate and flip all 3
blades for a perfect cut. When rotating and flipping the Blades, make sure all the Blades are adjusted at the same time
or else it could make the Blade Disc off balance. If your Landroid
®
M mows on a normal schedule (daily) then the Blades
should last one season if they are rotated and flipped every month. Always check to see if the Blades are chipped or
damaged and replace them if they are.
43
1 2
J
I

Worx WG794E Specifications

General

Brand	Worx
Model	WG794E
Category	Lawn Mower
Language	English