Worx WG794E - Battery Life; Winter Hibernation

Lawn Mowing Robot EN
15
C. Clean the contact pins and the charging strips
Clean the Contact Pins (3) located on the Charging Base (4) and the Charging Strip (5 )located on the Landroid
®
M using a
cloth. Remove any build up of grass clippings and debris around the contact pins and charge strips periodically to ensure
the Landroid
®
M successfully charges each time.
5.3 Battery life
The heart of the Landroid
®
M is its 28-volt lithium-ion battery. No
maintenance is required. For proper storage of the battery, make sure
it is fully charged in kept in a cool dry place between (20°C-60°C).
The life-span of the Landroid
®
M’s battery depends on various factors,
such as:
• Thetimespanofthemowingseasoninyourregion
• AmountofhourstheLandroid
®
M mows per day
• Batterymaintenanceduringstorage
Landroid
®
M can be charged manually without the boundary wire.
(See Fig. N)
To manually charge the battery without connecting the
boundary wire to the charging base;
1. Connect the Charging Base to a suitable power
supply.
2. Manually dock the Landroid
®
M into the Charging Base while the Landroid
®
M is powered off.
3. The charging base red light will turn on.
4. Within 3 seconds and before the charging base light turns green, press the Landroid
®
M power ON/
OFF button.
5. Landroid
®
M will begin to charge.
5.4 Winter hibernation
Your Landroid
®
M will live longer and healthier if it is allowed to hibernate. So even though it is tough, we would recommend
that you store your Landroid
®
M in your shed or garage during the winter.
Before you prepare your Landroid
®
M for winter hibernation, we recommend you:
• ThoroughlycleanyourLandroid
®
M.
• Fullychargethebattery.
• Turnthepoweroff.
To maximize the battery’s life, it is recommended to fully charge the battery before storage during winter.
The Boundary Wire can be left in the ground although its ends should be protected, such as placed in a tin can with grease.
If the Charging Base is left outside for winter, leave the Boundary Wire connected.
NOTE: Before storing for winter, you can take your Landroid
®
M to a dealer for a thorough cleaning and tune-up, where its
functions will be tested and worn parts will be replaced.
When bringing the Landroid
®
M back to work after winter hibernation, make sure the Charging Strips (5) and Contact Pins (3)
are clean, it is recommended to use a fine grade emery cloth to clean. Then make sure the date and time are correct and
send the Landroid
®
M back to what it loves doing: mowing.
1
2
N