18
EN
Your Landroid is inside its working
area and the boundary wire is
connected, but
‘– E1 –’ is displayed.
The boundary wire ends are clamped
incorrectly.
Reverse the boundary wire ends and reconnect
to the charging station.
The charging time is far more than
the rated charging time.
Poor connection caused by debris on
the charging strip.
Clean the contact pins located on the charging
base and the charging strip on Landroid using
a cloth.
The charging protection program is
activated due to high temperature.
Place the charging base in a shady area or wait
until the temperature has cooled down.
The mower does not charge. There is no power. Check the power cord is connected properly to
the charger and the charger is connected to a
suitable power supply.
Make sure both the charging strips on the
mower touch the centre of the
contact strips on the charging base.
Landroid is starting to have shorter
run-times between charges.
Something is clogging in the blade disc
creating friction and increasing power
consumption.
Take off the blade disc and clean it. Maybe the
grass is too high and too thick.
Landroid is shaking heavily because the
blade disc is unbalanced.
Check the blade disc and blades,
remove debris and foreign objects from the
blades and blade disc.
Replace the blades with a new set.
The battery may be exhausted or old. Replace battery.
The working time is up reset the working time
Landroid is not operating at the
correct time.
The clock is not set to the correct time. Set the clock to the correct time.
Programmed cutting times for Landroid
are not correct.
Change the time settings for the mower to start
and stop.
the percentage of weekly operating time
set through APP has changed.
set the correct percentage through APP.
Landroid cannot correctly dock
with the charging base.
Environmental influences. Restart Landroid.
Poor connection caused by debris on
the charging strip.
Clean the contact pins located on the charging
base and the charging strip on Landroid using
a cloth.
The green light on the charging
base turns on before charging is
complete.
the charging base is overheating or
overcooling
Place the charging base in a shady area or wait
until it reaches the normal temperature
Landroid wheels skid or repeatedly
slip.
Foreign obstacles, such as twigs and
branches may be lodged under
Landroid.
Remove foreign objects from underside of
Landroid.
The lawn is too wet. Wait until lawn has dried.
Landroid runs outside the boundary
wire.
Landroid does not mow an area
within a
boundary wire zone.
Landroid reverses or rotates
erratically near the boundary wire.
The boundary wire of another Landroid
or robotic mower is positioned too
closely.
Ensure at least 1m clearance is provided in
between your boundary wire and that of your
neighbor.
In wet conditions, the boundary wire
electric signal may leak where the wire
has been joined or repaired incorrectly.
Check boundary wire joints. Insulate to provide
a fully waterproof connection.
There is boundary wire electric signal
leakage due to broken insulation.
Repair damaged boundary wire
with the wire connectors supplied.
Landroid slips out of its working
area going down a hill.
Low grip of Landroid drive wheels. Please check the wheels are clean and free of
mud in order to have the
maximum grip possible.
To Next Page
Loading...
